Outdoor Use:
1. Slide (A1), with the orange spot pointing up, into A2 with the groove pointing down.
2. Insert the groove of the assembled Alignment Bar into the groove of the Support Arm ( B )
3. Push the Support Arm (B) into the hole on the Post Top (C).
4. If using outdoors on the putting green, insert the Long Post (C1) into the bottom of
Post Top (C).
Indoor Use:
1. Follow steps 1 thru 3 for outdoor use.
2. Install batteries into Laser (D) and slide laser into Laser Clip (E).
3. Insert Short Post (C2) into Post Top (C).
4. Insert Pro-
Click here for an animated video
of assembling the Pro-
IMPORTANT INFORMATION
* Unless you ordered the large base, the smaller
base will need some type of paper weight to
hold the unit up. We did this to keep the Pro-
lightweight and portable. If you would like the
large base, it’s available for purchase. Go to the
Shop link for accessories.
* When using the laser...
1. The laser stays on only when the button
is pressed. It does not stay on the entire
time. The laser is only used to ensure the
Alignment Bar is pointing where you want
it to.
2. Due to manufacturer irregularities, the laser may need to be calibrated. Here’s a simple test to see if it does. Install the laser
onto the Pro-
Hold the tip of the Alignment Bar up to a wall.
Press the button on the laser. It should be
pointing directly above the Orange Spot.
If it’s not, rotate the laser until it is pointing
directly above the Orange Spot. If you like,
once you have it aligned, drop a dab of
super glue between the laser and the laser
clip to keep it firmly in place.